Dimensional Contracting home page
Main Office

6720 Ridge Estates Court Arlington, Texas 76001

Office Hours

Mon-Sat: 7:00am-8:00pm

Main Office

6720 Ridge Estates Court Arlington, Texas 76001

Office Hours

Mon-Sat: 7:00am-8:00pm

Call now: (817) 502-9282Free inspection

Attic Insulation Removal in Grand Prairie, TX

Get my free inspection

Removing Failed Insulation From a Grand Prairie Attic

Insulation that a roof leak has soaked, or that rats, mice or squirrels have nested in and soiled, stops doing its job, and piling new material over it only buries the damage. Removal is the answer for that kind of attic, and the removal we offer is the full job: the failed insulation taken out, the bare attic floor cleaned and sanitized, and fresh fiberglass or cellulose blown back over every part of it.

Plenty of attics never need it. A dry, clean layer that has simply come up short can usually be built up instead, which attic insulation in Grand Prairie explains. A free look at the attic settles which one your house needs, and we tell you straight.

The business behind DC Attic Insulation is Dimensional Contracting, operating since 2003. We run our Grand Prairie jobs from the Arlington office and do not keep a branch in the city.

An attic with the old insulation cleared away, showing the ceiling drywall between the joists, wiring and a flexible duct

What Have You Found?

Droppings, nests, runs worn through the insulation, or an odor. Those point to animals living in it. Get the attic looked at before anyone pulls material out; soiled insulation is a reason to remove it, not to bury it.

A water stain on the ceiling, or wet insulation below a leak. Deal with the water first. When the roof is sound again, insulation that stays damp or was spoiled should be replaced. Fix My Roof DFW, our roofing company, handles roof repair in Grand Prairie.

Insulation pressed flat where people walk or things are stored. By itself, that does not mean it has to come out. The whole floor gets checked before we recommend anything.

A layer that is shallow but dry and clean. Topping up may do the job; ask about it when we visit.

Spray foam on the attic side of the roof or walls. We do not remove existing spray foam, so say so when you call.

Loose, granular fill in gray-brown or silver-gold. It may be vermiculite. The EPA’s advice is to assume it could contain asbestos and not disturb it, so mention it when you call, before anyone handles it.

Get a free inspection from Billy

Inspections and quotes are always free. There's normally no money up front, though we sometimes take a deposit on special orders.

Email updates

Billy calls you back to set a time.

We’ll only use your details to get back to you about this. See our Privacy Policy.

The Removal, From Start to Finish

Out It Comes

The old insulation comes out of the attic and out of the house. A cleared floor shows what the insulation sat on: framing, wire runs, ductwork and the openings cut into the drywall below.

The Floor Gets Cleaned

The empty floor is cleaned and sanitized before any new insulation goes down. We do not offer attic cleaning on its own; it only happens as part of a complete removal and replacement.

Air Leaks, While They Are Easy to Reach

A cleared floor is the best chance to get at the gaps where air from the house rises into the attic: around pipes and wires, along the top plates of the walls and at the hatch. Where sealing is part of the estimate, we fill those gaps with foam sealant and caulk before any insulation goes back. ENERGY STAR recommends sealing an attic’s air leaks before adding insulation. Attic air sealing lists where they usually turn up.

New Insulation Across the Whole Floor

Fresh fiberglass or cellulose is blown over the full attic floor to the depth written in the estimate. In the same estimate you will find the product and the R-value we are working toward, both drawn from the maker’s fact sheet. The higher the R-value, the greater the insulating power. Ask your seller for the fact sheet on R-values.

How the Job Is Priced

A removal is priced after we have been in the attic, since that is where the cost is decided:

  • Attic floor area. It is often well below a house’s total square footage, especially on a two-story home.
  • The old insulation. Wet or soiled material is slower to clear than dry.
  • Getting in and out. A small hatch, or one in a closet, adds time to every trip.
  • What goes back in, and how deep.
  • Air sealing, if it is done at the same visit.

Outside Our Work

Spray foam is not something we install or remove, and we do not install radiant barrier or work on ducts. We also do not clean attics as a stand-alone job or replace one section of insulation and leave the rest. We work on whole attics.

Grand Prairie Code and Permits

Since January 1, 2022, Grand Prairie has enforced the 2021 editions of the International Residential Code and the International Energy Conservation Code, both with the North Central Texas Council of Governments’ regional amendments, which alter the energy code’s ceiling insulation table and its air-leakage rules. Whether those codes reach insulation replaced in an existing attic is for the city to say. In the permit pages we reviewed, insulation comes up only as an energy-compliance inspection on new homes. Before the job starts, call Building Inspections, 972-237-8230, and ask what applies.

When Rodents Were in the Insulation

Insulation that rats or mice have lived in can be a health risk. The CDC says stirring up fresh droppings, urine or nesting material from an infected rodent can put hantavirus into the air, so the attic should be checked before anyone starts pulling material out. Any opening they used has to be sealed before the new layer goes in, or it can be soiled again. Tell us what you have noticed, and we will separate our share of the work from the pest control company’s.

Registration and Door-to-Door Sellers in Grand Prairie

Under Grand Prairie’s code, each general contractor doing work in the city has to register every year, and registrations run out each February 28. The rule says nothing about insulation work on its own, so check that your installer is registered. A door-to-door seller with no fixed place of business in the city needs a city permit requested at least 48 hours in advance. The code also makes it unlawful for a seller to go onto a private home’s property to sell unless the owner or occupant invited them. Knocking is not allowed before 9 a.m. or after 8 p.m. Monday to Saturday, or at all on Sundays, New Year’s Day, July 4th, Labor Day, Thanksgiving Day and Christmas Day. Those day and time limits do not make an uninvited visit lawful, and they do not apply to a visit you asked for. A seller must leave any home displaying a “No Solicitors” card unless the resident invited the visit.

A Grand Prairie Removal, Step by Step

  1. A free look at the attic, with the depth measured, the condition checked and any visible cause of damage noted.

  2. What we recommend, with a written price.

  3. The old insulation taken out of the attic and the house.

  4. The bare floor cleaned and sanitized, with any sealing in the estimate done while it is open.

  5. New insulation blown in to the depth we agreed, over the whole floor. Federal rules require the installer to give you a contract or receipt, dated and signed, that lists the area covered, the installed and minimum settled thickness, the R-value and the number of bags.

/ FAQS

Frequently Asked Questions

Areas We Serve

Get a Free Attic Evaluation in Grand Prairie

Call (817) 502-9282, or send the contact form with a line about what you found. We check the depth at a few points, see what shape the insulation is in, and tell you whether it should be removed, added to, or left. We are at 6720 Ridge Estates Ct in Arlington, and Grand Prairie is within our service area. The areas we serve page lists every city with a page of its own.

Call Us Now: (817) 502-9282Get my free inspection